motor runs only if we hold down the gas and the RPM above 2k.
Any clues?
it only has 86k on it and is a gorgeous car, but this issue is annoying.
FWIW we just replaced the battery. Car had sat for a while and the old battery was toast.
Reply 1 : 00 ES300 won't idle
You Tube |
|
|
Reply 2 : 00 ES300 won't idle
tried that, still no go.
I also swapped in new plugs (seriously needed them).
I can hold the idle with my foot, but only over 1k.
I also noted that there is what appears to be steam/water coming out of the tailpipe even after the motor is shut off. This leads me to fear a BHG, which isn't the end of the world, but it is a pain.
Reply 3 : 00 ES300 won't idle
Quote:
Originally Posted by internetauto tried that, still no go.
I also swapped in new plugs (seriously needed them). I can hold the idle with my foot, but only over 1k. I also noted that there is what appears to be steam/water coming out of the tailpipe even after the motor is shut off. This leads me to fear a BHG, which isn't the end of the world, but it is a pain. |
Run a compression check to confirm BHG. Otherwise, check all vacuum hoses for looseness, cracks,etc.
Also check TPS.
Reply 4 : 00 ES300 won't idle
well I have it idling now, but serious misfiring. it's so bad the alternator can't charge the battery at idle.
I did the old unplug the coil to see if it changes the idle trick and none of the front ones affected the idle. I didn't try the rear ones.
No comments:
Post a Comment